icon ISO 9001 · ISO 13485 · IATF 16949 · ISO 14001 certified manufacturer

Process Overview

Cable overmolding forms a protective profile around a prepared cable or connector transition. The review starts with the mating interface, installation envelope and handling loads, then considers material compatibility, tooling and the inspection plan. Samples should be checked for fit, dimensions and electrical performance before the construction is released. Any ingress requirement applies to the complete agreed assembly and its specified verification conditions.

Cable Overmolding process detail

Inspection & verification

  • iconMeasure first-article profile, cable exits and interface dimensions against the drawing
  • iconInspect for incomplete filling, excess flash and surface defects
  • iconVerify sealing performance where an ingress requirement is specified
  • iconCheck the completed assembly electrically after molding to the approved test plan

iconProcessing Range

Materials

TPU, PVC, TPE and silicone; material and tooling compatibility reviewed per project

Material hardness

Shore A 55–95, subject to the selected material grade

Molded length

10–120 mm typical; confirm against the profile drawing

Ingress protection

IP65–IP68 constructions are design-dependent and require agreed verification

iconEquipment

  • Vertical injection molding machines

    10 units for project-approved molded constructions

  • Mold temperature controllers

    10 units supporting repeatable mold conditions

  • Insert loading stations

    6 stations for cable and connector positioning

  • Sealing test benches

    2 benches supporting the agreed sealing checks

Process Steps

Five controlled stages, each with a defined check before the batch moves on.

  1. 01

    Define the profile

    Review cable exits, interface dimensions, service loads and the proposed material.

  2. 02

    Prepare tooling

    Confirm mold design and approve sample fit before releasing the production configuration.

  3. 03

    Locate the insert

    Support and position the prepared cable assembly so the molded geometry remains controlled.

  4. 04

    Mold and cool

    Run the approved process settings, cool the part and remove it without damaging the assembly.

  5. 05

    Inspect and release

    Complete dimensional, appearance, sealing and electrical checks required by the inspection plan.

Frequently Asked Questions

If your question is not answered here, the enquiry form below reaches the process engineers directly.

When should we consider an overmolded construction?

Consider it when the application needs a defined cable exit, integrated strain relief or a protected transition. Review tooling cost against expected quantities, installation requirements and the alternatives before selecting the construction.

Provide the operating temperature, fluids, outdoor exposure and required flexibility. Material selection also depends on adhesion, cable-jacket compatibility and the molding process; the grade should be agreed before sampling.

Send the connector identification, drawing and a sample if available. The review considers heat and pressure exposure, sealing surfaces, insert support and the space available for the molded profile.

No. Performance depends on the cable, connector interface, molded transition and installation. Specify the intended ingress rating and test conditions so the complete assembly can be evaluated against an agreed requirement.

Discuss Your Sample Requirements

Send a drawing or a sample and we will build a first article to the agreed inspection plan so you can validate the process before committing to volume.

Tell us what you need to build

Send a drawing, a BOM, a part number or just one sentence. Our engineers review every enquiry and reply within 24 hours.

  • Engineering review within 24 hours
  • NDA available before drawings are shared
  • Free samples in 5-7 days after drawing approval
Inquiry Drawer

Review & Submit Request

This site uses cookies

We use cookies to collect information about how you use this site. We use this information to make the website work as well as possible and improve our services.more details