Checks from incoming materials to final release
Incoming, in-process and outgoing inspections help us verify materials, assembly quality and finished products against the agreed requirements.
Incoming quality control
Every incoming reel, terminal and connector batch is verified against specification before it is released to the line.
- Wire gauge & insulation
- Terminal plating & dimensions
- Connector & housing check
- Reel & batch logging
In-process quality control
Checks run while the line is producing, so a drift is caught before the batch is finished.
- Strip quality & strand damage
- Crimp height & width
- Pull-force test
- Assembly & labelling
Outgoing quality control
Finished assemblies are released only after electrical and dimensional verification against your drawing.
- 100% continuity test
- Hi-pot test
- Dimensions & appearance
- Shipment records
Testing & Inspection Methods
Testing requirements depend on the cable design and its intended use. The methods below help verify the characteristics specified for each project.
Continuity Test
100% pinout verification against your drawing
Hi-pot Test
Dielectric strength on insulation-critical assemblies
Pull-force Test
Crimp and joint strength against the component datasheet
Crimp Height & Width Measurement
Crimp geometry measured per batch, not by eye
Micro-section Analysis
Cross-section of strand compaction and crimp
Visual & Dimensional Inspection
Final appearance and critical-dimension check
Need quality documents for supplier approval?
Request certificates, inspection plans or sample test records from our team.
Tell us what you need to build
Send a drawing, a BOM, a part number or just one sentence. Our engineers review every enquiry and reply within 24 hours.
- Engineering review within 24 hours
- NDA available before drawings are shared
- Free samples in 5-7 days after drawing approval